The conveyor belt of the security inspection machine will friction with the roller, conveyor, and delivery port during use. The greater the friction, the greater the damage to the conveyor belt. In order to reduce the wear of the conveyor belt, it is necessary to understand the main friction parts of the conveyor belt. The main friction part of the conveyor belt is introduced as follows.

1. Sometimes the conveyor belt has some defects during the manufacturing or installation process, which leads to deviation during the working process, which increases the friction between the conveyor belt and the bracket.

2. The friction between the roller and the conveyor belt, the lower cover rubber of the conveyor belt is also rubbed by the centering roller and the inclined groove roller.

3. Cleaner and friction conveyor belt. If the conveyor belt cleaner is used improperly, it will increase friction and cause abrasion, and in severe cases, it will cause scars.

The conveyor belt of the security inspection machine will not only be worn, but also some dirt will be stained after the conveyor belt is used for a long time. This will not only affect the transportation speed, but sometimes also make the conveyor belt run, so everyone should remember to clean up in time and keep the surface of the belt. clean. So how do you clean the conveyor belt?

1. First of all, before cleaning, all electrical equipment that is afraid of water needs to be wrapped with a water-proof film to prevent water from entering the equipment and causing short circuits.

2. Close the valve, observe the tensioning device, and adjust the pressure of the device.

3. Check the working status of the washing machine and check whether the conveyor belt is in good condition. Damaged parts must be repaired in advance before cleaning.

4. In order to better clean the conveyor belt, the conveyor belt should be moistened before cleaning.

5. Use a low-pressure spray gun to evenly spray and stir the cleaning liquid evenly. Please be careful not to use a high-pressure spray gun because it will damage the belt surface.

6. Rinse with water. Check whether there are stains on the conveyor belt of the security inspection machine, and dry the belt to prevent mold.