The x-ray security inspection machine is used to detect luggage and bags.The operation items of the x-ray security inspection machine can be divided into four parts.Let me share with you the precautions of the x-ray security inspection machine from power-on inspection to shutdown.

1.Startup inspection:pre-inspection must be carried out before startup.The electromagnetic wave protection curtain at the entrance of the security inspection channel should be in good condition.All covers must also be covered.Check whether the conveyor belt of the security inspection machine is complete and clean.Check if there is anything in the channel.

electromagnetic wave protection curtain

2.Start:Insert the bus into the power supply,insert the key,and then rotate it 90 degrees according to the use of the ordinary key.Then press the host to power the machine,and the system executes the initialization program.This means that the security check is ready.

3.Target detection:There is another very important step before target detection,which is to conduct equipment training and management according to F12.Put the items on the conveyor belt and maximize the contact area between the items and the conveyor belt.The object enters the tunnel to block the light barrier,and the x-rays begin to transmit the line to scan the object.When all this is done,the detector will receive a signal about the object,and the system will transmit the signal to the display.If you find something suspicious,you can press the pause button to observe.

4.Shutdown:One-key shutdown,just press the shutdown button on the console and take out the key.

There are very few things that should be paid attention to during the operation of the X-ray security inspection machine.As long as the operating procedures are followed,there will be no accidents.However,after all,X-rays are very dangerous,so you must not go over the electromagnetic wave shield to take things to avoid X-ray radiation damage.

We must operate in accordance with the operating regulations of the safety inspection machine to avoid accidents caused by malfunctions.